TECHNICAL DATA FOR 1PH230V10HP

UNDERLOAD OR LACK OF FLUID
Coyote shuts off the pump within one second of running dry, and automatically restarts the pump at any time you dial on the timer from one minute to twelve hours.

        trip delay                       reset delay
        1 second                        adjustable
                                          1 minute - 12 hours

OVERLOAD
Coyote's microprocessor circuit memorizes the normal running current of your pump's motor. If Coyote shuts down the pump due to excessive current, it will restart it sixty seconds later. If the motor draws normal current Coyote will allow it to run. If, however, after two consecutive attempts one minute apart the motor continues to draw excessive current, Coyote locks out the pump so as not to burn out a motor winding and the overload light changes from on steady to blinking.

      trip amps               trip delay           reset delay
 150% of normal        1/4 second          60 seconds

VOLTAGE FAULT
Plus or minus 2%
                                     low voltage       high voltage
        Model                 trip    reset        reset    trip
1PH230V10HP          190V   200V         260V   270V

             trip delay              reset delay
            2 seconds              60 seconds

RANDOM START
When energizing Coyote by turning on power at circuit breaker or fused disconnect there is a delay of 4 to 10 seconds before Coyote turns on the pump. This "random start" feature is designed to prevent many pumps served by a single power source from all restarting at the same instant when power is restored after a power outage.

ALARM
If you wish to ring a bell, light a light, or activate some other alarm, Coyote's normally open dry alarm contact closes on any fault condition.

HORSEPOWER RATING
1PH230V10HP           1 - 10 HP

OPERATING RANGE

-20° to 70° C temperature
0% to 95% humidity noncondensing

OVERALL DIMENSIONS

11 1/2"H x 6"W x 4"D
(including mounting tab at top)

 

 

 

WWW.COYOTEMFG.COM